Grab your wedge tools from production youll need a drill and the wedge tool. Go up to northern raisable and push out the wedge still to the middle of transverse

Start collecting the barries around the wedge. Make sure you are bendung your knees to pick up these as they are heavy.

Continue walking the barries up the stairs, take it slow. These can be a x2 person lift if needed

Once you have carried up a barrier to the stillage, place the barrier down and resposition yourself to easily slide the barriers on the stillage.

Once you have finished collecting the barries on the bottom of the stillage there is metal pieces. Start taping these down on every gap, shorter pieces will be used for the middle section, larger ones for the outsides

Put the shorter metal peices in the middle closest to the south to have enough room for the stairs to be placed in

Larger metal peices will be used to cover the whole gap as there is no stairs to be placed.

After all the gaps have been covered with the metal, on the wedge stillage youll find carpet squares use this to cover the holes from the barriers

Then grab the non slip tracking, screw each piece in directly in the middle of the wedge. There will be a piece for each wedge step

Grab your stairs make sure they are the correct row, slot the stairs on the rail. Make sure they are locked in to safely walk on

Continue locking in the stairs all the way down the wedge

Grab your bank of chairs, they will be right in front of another row. Make sure not to slide the chairs over your wedges as you could rip your tape youve just put down

Line up your seats with the base plates on the ground, to lock in the seats tilt the bank backwards and slide to the wall to get the back locked under the rail. Once both sides are in, tilt the seats forwards to make it flush

Under each post there will be a locking switch, use your wedge tool to get under it and pull up. This will shoot out your locking pin to sit under the d-ring

Continue putting in all seats on the wedge, make sure you are locking them in or else these banks of seats will be unstable

To finish up installing the wedge make sure you collect all your tools and rubbish. Push your full wedge stillage behind the northern rasiable curtain and put your tools back in production