Knowby Heg Automotive Pty Ltd
Knowby
MAYKA - Air Hose Reel
Building your MAYKA Hose Reel.
Building your MAYKA Hose Reel.
1
Step 1 of 1
PDFMAYKA_Hose_Reel_Fitting_Instructions.pdf Open document

Attach block 1 to the reel

Bolt mounting block 1 (part 2) to the hose reel (part 1) using the M8 × 12 hex socket screws (part 4).

2 Attach block 2 to block 1

Fit mounting block 2 (part 3) to mounting block 1, then tighten it down with more M8 × 12 screws (part 4).

3 Place the channel nuts

Slide the two M6 channel nuts (part 6) into the mounting channel.

4 Mount the reel

Line the assembled reel up with the channel nuts. Fasten it with the M6 × 18 hex socket screws (part 5), each fitted with a spring washer (part 7) and a flat washer (part 8), then tighten fully.

4 Mount the reel Offer the assembled reel up to the rack and line it up with the channel nuts. Fasten with M6 × 18 hex socket screws (part 5), each with an Ø6 spring washer (part 7) and an Ø6 × 16 × 1.5 flat washer

(part 8). This is the fixing marked 03. Tighten fully.