

Wear your PPE
Wear the personal protective equipment required for this machine at all times. This is for your own safety.
Safety shoes with integrated steel toe caps to protect your feet
Ear protection
Hard hat: protects from falling objects on the construction site
Protective gloves: prevent injuries to the hands
Safety glasses: help prevent injury from flying particles
Safety vest: keeps you highly visible on the job site
Set the throttle to idle
Hold the rammer by the control handle.
Switch the throttle lever to idling (stationary).
This automatically opens the fuel cock.
Press the purge bulb
Press the purge bulb 10 times until it is completely filled with fuel.
Set the choke on a cold engine
For a cold engine, also press the choke until it locks into place.
Pull the starter rope
Pull the starter rope of the recoil starter several times until the engine begins to run.
Release the choke
Move the throttle lever slightly past the red area.
This way, the choke automatically jumps back.
Let the engine warm up
Give the engine a few moments to warm up.
Open the throttle
Activate the throttle lever until you reach the desired rpm.
Vibration starts and the rammer moves forward.
Guide the rammer
Always hold the rammer with both hands during operation.
Slowly guide the rammer over the area to be compacted. Keep a steady hand.
Switch off
Move the throttle lever to off.
The engine stops running and the fuel cock closes automatically.
Refuel: one tank filler neck
First check whether the rammer has one or two tank filler necks.
If there is only one filler neck, refuel with a two-stroke mixture with a ratio of 1:50 to 1:100. Ready-made two-stroke mixtures are available for purchase.
A two-stroke engine must not be refuelled with ordinary petrol or diesel.
Refuel: two tank filler necks
On models with two filler necks, refuel oil and petrol separately. The two-stroke mixture is created within the rammer.
Only fill the tank with the fuel pump symbol with petrol.
Refill the tank with the oil symbol with two-stroke oil every 120 operating hours.
You will find detailed information in the operator's manual.