Begin by grabbing a canopy crate and removing the top from the base. If the canopy has a roof rack, place underlay on the base and cable tie the roof rack extension to the base. It is important that no part of the extensions is touching the base and that it is cable tied securely down. Cable tie the box of canopy components. Before doing this, triple check that everything is in the box. 

Place wooden squares close to each corner of the base. Lower your canopy down and move the wooden square under the x4 hold down brackets in each corner of the Artemis. Using a 90 degree drill, drill a 8mm hole through the wooden square and base. Fasten a M8 bolt and nyloc through the base like so to secure the Artemis down. 

Place the top back on to the base. Fasten a screw at each point where the base and top meet. Using a red marker, mark around each of the screws.

Take the black wrap and cover the crate. Staple the wrap tightly to the crate. Cut any excess at the bottom. 

Place the M2 serial number that is provided on the face of the crate that the forks go in. Your Artemis shipment is now complete.