
Tools required
No2 Phillips screwdriver
Masking tape
Marking pen
3mm Allen key
8mm spanner
Drill
3mm drill bit
7.5mm drill bit
5mm Rivnut gun
Debuting tool
Drill stop

Step One
Unpack and lay out parts.
Note position of brackets
The supplied fitting hardware includes:
5x Mounting Brackets
12x M5 Dome head Bolts
6x M5 Rivnuts
6x M5 Hex Nuts

Step Two
Mask door

Step Three
Fit brackets to plate.

Step Four
Have assistant hold plate in place and mark the holes to be drilled.

Step Five
Drill 3mm pilot hole and then drill holes out to 7.5 mm. De bur and apply rust prevention.
Fit rivnuts.
Remove swarf

Step Six
Remove brackets from plate and fit to the door

Tip: put small amount of masking tape on spanner to hold nut for easy installation.

Tip: put small amount of masking tape on spanner to hold nut for easy installation.