Unroll the keg wrap by releasing the ratchet.

Throw the wrap to loop over the left side of the load, so the document pouch is aligned to the front right edge of the pallet. 

Walk around the pallet, guiding the webbing half-way up the keg and holding any slack.

Pull the webbing through and away from the ratchet, and secure the load by wrenching tight.

Feed the front base strap under the side of the pallet to secure the load.

Create tension by pulling the strap over the main webbing, beside the ratchet.

Apply the base strap in the same way to the opposite side of the pallet.

Note: when securing less kegs, the base straps can be fed through the top slats of the pallet. 

To remove, release each base strap and open the ratchet for the webbing to come loose.

After use, lay the wrap flat, logo-facing down.

Pull the webbing through so it lies flat against the canvas.

Before rolling, create a z-fold from the end opposite the ratchet

Roll from the side opposite the ratchet, tucking the base straps into the roll. 

Secure by closing the ratchet and wrapping the webbing around the roll until it meets the velcro.