Trim central locking pickup until you reach the two single green and blue wires.

Cut wires at this location

Plugs are not required.

Trim the green and blue wires and crimp onto connectors

Place rubber grommets over wires

Place connectors inside plug ensuring colors match on both sides of plug

Your wiring harness should now look like this.

Disconnect earth terminal on vehicles battery

Feed wiring loom down through engine bay

Take off bonnet open leaver from kick panel

remove kick panel and side trim to allow access to the entry point under drivers side carpet

Unpin the vehicle cabin connection plug from the wiring loom

remove rubber grommet

Trim split tube and place shrink tube over wiring

Place connectors through rubber grommet

Place loom wiring through entry point and secure rubber grommet

Run vehicle loom and secure wiring under vehicle using cable ties where required

Re-pin plug and connect to internal wiring

Place buzzer in location and connect

Place fuse tap in location shown and connect to wring loom

Central locking plug (Black) is located around the fuel filler area under the vehicle

look for plug shown

Connect plugs as shown

Connect earth to vehicle as shown and connect positive terminal to battery

Tidy all wiring and secure with cable ties as required