Get one pump of chloridet into a bucket

Fill the bucket up to half full with hot water

Fill rest of bucket with cold water so bucket has a bit of chloridet and warm water

Go into workshop and turn the blue tap off near disc filter and make sure pump turns off

Use screw driver to undo the collar on disc filter

Take top off filter

Use pipe wrench to take the disc cylinder off holder

Take top out of filter

Place the tops in your bucket of chloridet

IMPORTANT: the discs all come off the same way and go back on the same way.

Use rope to loop disc filters onto keeping them the same way they come off.

Tie string up remembering which end is which

Let filters soak for 10mins and then individually clean each filter by hand

Take bucket to the spray fill point

Rinse out filter pieces once you’ve emptied and refilled your bucket

Tie string back onto pipe and put filters back on

Put cap back on

Use wrench to tighten up but Don’t overtighten it

When putting lid back on make sure rubber seal is sitting properly

Put lid back on and tighten collar

Open up water tap and turn pump on