

Wear your PPE
Wear the personal protective equipment required for this machine at all times. This is for your own safety.
Safety shoes with integrated steel toe caps protect your feet.
A safety vest keeps you highly visible on site at all times.
Check the battery isolator switch
Before you climb into the excavator, check that the battery isolator switch in the engine compartment is in the plug position.
If it is not, plug the isolator switch into the plug position and turn it half a rotation clockwise.
Climb in safely
While climbing into the excavator, always keep three points of contact with the machine.
Seat belt
Fasten the seat belt.
Start the engine
Insert the ignition key and turn it clockwise.
Preheat briefly at half rotation.
Turn the key fully.
Armrest
Now fold the armrest down.
Left joystick
Move the left joystick to the right or left to turn the revolving superstructure.
Move it forward or backward to control the shovel arm (dipper).
Right joystick
Use the right joystick to operate the shovel (bucket) and the boom.
Move it right or left to roll the shovel in and out.
Move it forward or backward to move the boom up and down.
Both movements can be made at the same time.
Triple boom
The pedal on the left side of the footwell extends the triple boom.
Make sure the shovel does not damage the boom. This can happen if all cylinders are completely retracted.
Swivel the boom
The boom can be swivelled using the right pedal in the footwell.
Dozer blade
The dozer blade is moved using the lever next to the right joystick.
Travel
To move the excavator, use either the foot pedals or the operating levers.
Forward: press both levers or pedals forward.
Reverse: press both backward.
Steer right: operate only the left lever or pedal.
Steer left: operate only the right lever or pedal.
Turn the machine: operate one forward and the other backward.
Travel speed
Use the green touch control on the dozer blade lever to choose between high speed (rabbit) and slow speed (turtle).
Before you drive
Bring the shovel arm and the boom into a horizontal position.
Make sure the dozer blade is aligned with the travel direction. Otherwise the pedals work in reverse.
Change the attachment
The attachment is changed using the quick coupler system, which can be activated mechanically or hydraulically. The hydraulic quick hitch is the easier option.
Pull the lock above the left switch downward.
Press the unlocking touch control.
Within 10 seconds, press the right Easy Lock touch control to open the quick coupler.
Once the bolts are unlocked, place the attachment down, lift the arm system and pick up the new attachment.
Lock the quick coupler
To lock, press the unlocking touch control back into its original position.
Make sure the locating pins are fully extended.
If required, test this.
Hydraulic attachments
With hydraulic attachments you must also connect or disconnect the hydraulic hoses between the excavator and the attachment. First depressurise the hydraulic system:
Switch the engine off and move the ignition to position 1.
Move the rocker switches on both joysticks back and forth. The hydraulic system is now depressurised.
Caution: with pressure on the utility lines, disconnecting the couplings can be difficult or impossible.
Make sure the locating pins are fully extended and, if required, test this.
Shut down
Lower the arm system until the attachment lies flat on the ground.
Lower the dozer blade.
Turn the ignition key to the left and pull it out.
Blind areas
The excavator has a large blind area, especially on the right front side.
The rear counterweight swings out while turning.
You will find detailed information on using this machine in the operator's manual.