Knowby
Wacker Neuson DV60, DV90, DV100 – Standstill Regeneration
How to carry out a standstill regeneration of the diesel particulate filter on Wacker Neuson DV60, DV90 and DV100 dumpers with EU Stage V engines, and what the warning lights mean. Not a substitute for the operator's manual supplied with the vehicle.
How to carry out a standstill regeneration of the diesel particulate filter on Wacker Neuson DV60, DV90 and DV100 dumpers with EU Stage V engines, and what the warning lights mean. Not a substitute for the operator's manual supplied with the vehicle.
1
Step 1 of 9

Regeneration required

When a standstill regeneration is required, the Regeneration required control light flashes on the display.

2
Step 2 of 9

Check the engine temperature

Open the menu display. The engine temperature must be above 60 °C (140 °F).

3
Step 3 of 9

Check your surroundings

Attention: do not perform a standstill regeneration in environments with easily flammable material.

4
Step 4 of 9

Start the regeneration

  1. Press switch 1, the red parking brake switch.

  2. Press and hold switch 2, on the far left of the switch panel, for 3 seconds.

5
Step 5 of 9

Regeneration active

The display shows that standstill regeneration is active. In the menu display, the clock symbol flashes during the warm-up phase.

Attention: do not leave the vehicle unattended during regeneration.

6
Step 6 of 9

Remaining time

The display shows the remaining regeneration time.

During standstill regeneration, the drive system and the working hydraulics are locked.

7
Step 7 of 9

End of regeneration

The clock symbol flashes at the end of regeneration. The standstill regeneration is terminated automatically.

8
Step 8 of 9

Heavily loaded filter

If the load on the diesel particulate filter (DPF) has increased greatly, the Regeneration required control light flashes and the Engine warning control light comes on.

The vehicle can only be operated to a limited extent. The standstill regeneration process is the same.

9
Step 9 of 9

Service regeneration

If a service regeneration is required, or the diesel particulate filter has to be replaced, the Engine stop control light comes on and the Regeneration required control light flashes quickly.

The vehicle can no longer be operated. Contact Technical Support.

For further information, refer to the vehicle's operating manual.