Knowby
Wacker Neuson RTD-SC4 Trench Roller – Steering Calibration
How to calibrate the steering on the Wacker Neuson RTD-SC4 trench roller from the transmitter: right, straight and left positions, followed by a return-to-centre test.
How to calibrate the steering on the Wacker Neuson RTD-SC4 trench roller from the transmitter: right, straight and left positions, followed by a return-to-centre test.
1
Step 1 of 17

Turn on the transmitter

Turn on the transmitter.

2
Step 2 of 17

Press the start button

Press the start button on the left.

The horn will sound before the engine starts and preheats.

3
Step 3 of 17

Open the settings page

  1. Use the down button to navigate to the settings page.

  2. Press the enter button.

4
Step 4 of 17

Go to the calibration page

Navigate to the calibration page.

5
Step 5 of 17

Read the live steering sensor values

Press and hold the steering button for 10 seconds to read the live values of the steering sensor.

Calibration activates when the steering sensor values are available.

6
Step 6 of 17

Watch for the screen time-out

The screen will time out after 30 seconds. You may have to navigate back to the calibration page.

7
Step 7 of 17

Read the two numbers

  • Top number: current sensor value.

  • Bottom number: current position.

8
Step 8 of 17

Identify the calibration position

The arrows identify the roller calibration position: right, straight or left.

Make sure the position is set before calibration.

9
Step 9 of 17

Right calibration: steer fully right

The arrow identifies the calibration being performed.

  1. Steer the machine fully to the right.

  2. Stop paddle movement when the machine reaches the right stop.

10
Step 10 of 17

Save the right position

Press the enter button twice to save the new right position. The new calibration saves to the stored value position.

The right position is now calibrated.

11
Step 11 of 17

Select the straight position

Arrow down to the straight calibration position.

12
Step 12 of 17

Steer the roller straight

  1. Steer the roller into the straight position.

  2. Use a straight edge on the drums to confirm the straight position.

13
Step 13 of 17

Save the straight position

Press the enter button twice to save.

14
Step 14 of 17

Select the left position

Arrow down to the left calibration position.

15
Step 15 of 17

Left calibration: steer fully left

  1. Steer the roller to the left position.

  2. Stop paddle movement when the machine reaches the left stop.

16
Step 16 of 17

Save the left position

Press the enter button twice to save the value.

Steering calibration is now complete.

17
Step 17 of 17

Final test: return to centre

As a final test, check that the roller returns to centre.