Remove aerial.

Install car cover and ensure it’s between cab and well side to prevent scratching.

Remove tail gate inspection panel.

Remove camera bracket and note orientation.

Remove clips.

Remove clips and remove camera harness.

Remove tail lights and unplug. Feed harness out of well side and remove all clips.

Remove plug and cut tail light wires at the earth junction. Feed harness out of well side and remove all clips.

Remove fuel cap retainer. Remove all clips inside inner guard on passengers side rear.

Remove inner guard.

Remove fuel flap latch arrangement and filler neck support bolt.

Remove bumper mount bolts. Note make sure the bolts are reinstalled as they often secure the tow bar as well.

Remove bumper. Ensure all wires are disconnected.

Remove all reverse sensor wires and clips. Note left and right orientation is important not to mix up.

Reinstall clip arrangements so they don’t get mixed up. Now is a good time to install sensors in M2 brackets.

Remove all 6 wellside mounting bolts.

Hook up lifting slings.

Make sure weight is balanced evenly so wellside lift off level.

Take care when lifting. Ensure all clips and wires are disconnected and there’s cover between cab and wellside to prevent scratches.