Knowby
Wacker Neuson Excavators – Tilting the Cab for Service
How to tilt the cab on certain Wacker Neuson wheeled and tracked excavators to gain full access to maintenance and service components. Always refer to the operator's and service manual before working on any Wacker Neuson machine.
How to tilt the cab on certain Wacker Neuson wheeled and tracked excavators to gain full access to maintenance and service components. Always refer to the operator's and service manual before working on any Wacker Neuson machine.
1
Step 1 of 10

Tools you will need

  • Punch

  • 8 mm hex socket

  • 14 mm hex socket

  • 3/8 drive ratchet and extension

  • 1/2 drive ratchet and extension

  • Two 9 mm wrenches

Always refer to the operator's and service manual before working on any Wacker Neuson machine.

2
Step 2 of 10

Position the boom

Position the boom and dipper stick completely forward before tilting the cab. Swivel the boom to the right if required.

3
Step 3 of 10

Remove the cab bolts

Remove the four bolts from inside the cab: two behind the seat and two underneath the floor mat.

4
Step 4 of 10

Fit the cab pivot bolts

  1. Remove the front panel to reach the mounting points for the cab pivot bolts, to the left and right of the cab pivot points.

  2. Remove the bolts from the second hole behind the pivot points and install them in the pivot points.

5
Step 5 of 10

Attach the block and tackle

Position the block and tackle between the lifting hook of the cab and the stabiliser blade.

6
Step 6 of 10

Start lifting the cab

Begin winching the cab forward. Lift the cab about 12 to 14 inches (30 to 35 cm) off the frame.

7
Step 7 of 10

Check the safety cable

Verify that the safety cable is attached to the cab and the frame before pulling the cab completely forward.

8
Step 8 of 10

Tilt the cab fully

Fully tilt the cab forward using the block and tackle. Pull the cab handle until the cab is completely forward.

9
Step 9 of 10

Fit the safety bar

Place the red safety bar, with its pin, between the cab and the frame.

10
Step 10 of 10

Access for service

With the cab tipped forward you have full access to the service and maintenance components under the cab.

Additional access to the engine is available through the access panel.