

Brake 04 – Changing top tools (punches)
Category: Ragos Press Brake > Tooling. How to remove and fit top tool segments in the quick-release clamps and register them in the controller.
Category: Ragos Press Brake > Tooling. How to remove and fit top tool segments in the quick-release clamps and register them in the controller.
1
Step 1 of 6
Raise the head (top beam) before you touch the tools. Keep your feet off the pedal while your hands are in the tools.
2
Step 2 of 6
Release the top clamps by flipping the red handle.
3
Step 3 of 6Take the old segments off and put them back on the tooling trolley. Clean them and wipe them with oil first (Brake 12).
4
Step 4 of 6
Pick the segment sizes you need to make up the bend length. The ears (horn segments) go on the ends.
5
Step 5 of 6Set the segments in place by hand, then flip the red handle to tighten the clamps.
6
Step 6 of 6
Enter the finger position under Z1 and Z2 in the controller.