Knowby
Brake 05 – Changing bottom dies
Category: Ragos Press Brake > Tooling. How to remove and fit bottom die segments and register them in the controller.
Category: Ragos Press Brake > Tooling. How to remove and fit bottom die segments and register them in the controller.
1
Step 1 of 6
<p>Raise the head (top beam) and loosen the clamps before you touch the dies.</p>

Raise the head (top beam) and loosen the clamps before you touch the dies.

2
Step 2 of 6

Loosen the bottom spacers with the allen key.

3
Step 3 of 6

Take the old die segments off and put them back on the tooling trolley. Clean them and wipe them with oil first (Brake 12).

4
Step 4 of 6
<p>Pick the die segment sizes you need to make up the bend length. The ears go on the ends.</p>

Pick the die segment sizes you need to make up the bend length. The ears go on the ends.

5
Step 5 of 6

Set the die by hand, then tighten the bottom spacers with the allen key, hand tight only.

6
Step 6 of 6
<p>Enter the finger position under Z1 and Z2 in the controller.</p>

Enter the finger position under Z1 and Z2 in the controller.