Knowby
Laser 20 – Changing slats
Laser category. Replacing worn or bent bed slats. [REVIEW: general practice, no operator notes yet]
Laser category. Replacing worn or bent bed slats. [REVIEW: general practice, no operator notes yet]
1
Step 1 of 6
<p>Change a slat when it is cut down too low, bent, or the sheet won&#39;t sit flat on it.</p>

Change a slat when it is cut down too low, bent, or the sheet won't sit flat on it.

2
Step 2 of 6
<p>Park the head clear of the bed and turn the laser off before you reach in.</p>

Park the head clear of the bed and turn the laser off before you reach in.

3
Step 3 of 6
<p>Lift the old slat straight up out of its slot. Wear gloves because the edges are sharp.</p>

Lift the old slat straight up out of its slot. Wear gloves because the edges are sharp.

4
Step 4 of 6
<p>Drop the new slat into the same slot, with the points facing up. Make sure it sits fully down and level with the others.</p>

Drop the new slat into the same slot, with the points facing up. Make sure it sits fully down and level with the others.

5
Step 5 of 6

Spread new slats around the bed rather than grouping them, so the sheet sits evenly.

6
Step 6 of 6

Put the old slats in the scrap bin. Tell the manager when spares are low.