

Laser 04 – Compensation and the saved parameter library
HSG Laser > Job setup. Where our saved cutting parameters live, our kerf compensation values by thickness and gas, and how to check them with a test part.
HSG Laser > Job setup. Where our saved cutting parameters live, our kerf compensation values by thickness and gas, and how to check them with a test part.
1
Step 1 of 10
Our saved cutting parameters are in the material library, sorted first by cutting gas, then by material thickness.
2
Step 2 of 10
Mild steel cut with oxygen: use the compensation values in the table (mm). Outer is always the bigger number.
3
Step 3 of 10
Stainless steel cut with nitrogen: use the compensation values in the table (mm). Outer is always the bigger number.
4
Step 4 of 10To check compensation, cut a 50 x 50 mm square with a 12 mm hole in the centre. Measure the square and the hole with verniers. Use the values above as your starting point.
5
Step 5 of 10Now we'll go here to okay, and it's going to ask us where we're going to turn it, we're going to return it to the correct machine coordinate, and it's going to bring it down here to its home position corner, at this point now we can turn our laser beam back on, I'll get it back on position.
6
Step 6 of 10Now we can come down here to our custom and we'll turn our laser power on.
7
Step 7 of 10And now we have to wait here 10 seconds so we can turn our shutter on. You have to wait 10 seconds or else the laser will not work.
8
Step 8 of 10Now we'll turn our shutter on and now we'll go down here and we'll stop the test.
9
Step 9 of 10Shutter is on and now our power is on and we're going to cut.
10
Step 10 of 10A new or improved parameter set must be approved by the manager before the old backup is deleted. Keep the backup until then.