Knowby
Laser 10 – Unloading parts and skeleton
HSG Laser > Production. Getting parts and skeleton off the fixed bed, checking parts off, handling offcuts and clearing the bed.
HSG Laser > Production. Getting parts and skeleton off the fixed bed, checking parts off, handling offcuts and clearing the bed.
1
Step 1 of 7
<p>Lift small parts off with a magnet. Lift big parts with the vacuum lifter, or with magnets on the hooks under the lifter.</p>

Lift small parts off with a magnet. Lift big parts with the vacuum lifter, or with magnets on the hooks under the lifter.

2
Step 2 of 7

Knock parts out of their micro-joints with the handheld jackhammer.

3
Step 3 of 7

As each sheet is cut, mark each part off the parts list and put it on the stillages or in the cassettes.

4
Step 4 of 7

If a part is wrong, mark it down and tell the manager.

5
Step 5 of 7
<p>Cut the skeleton up with a cut-up, then remove it with the forklift into the offcut bin.</p>

Cut the skeleton up with a cut-up, then remove it with the forklift into the offcut bin.

6
Step 6 of 7

Any offcut bigger than 400 mm square goes on the offcut rack.

7
Step 7 of 7
<p>Clear everything off the bed before the next sheet. Clean the slats every other week, or before a stainless or aluminium sheet.</p>

Clear everything off the bed before the next sheet. Clean the slats every other week, or before a stainless or aluminium sheet.