

Brake 08 – Creating a new auto program (Delem DA-66S)
Category: Ragos Press Brake > Programming (DA-66S). Building a saved auto program for repeat parts with several bends: drawing the profile, tooling, checking the bend sequence and saving by part number.
Category: Ragos Press Brake > Programming (DA-66S). Building a saved auto program for repeat parts with several bends: drawing the profile, tooling, checking the bend sequence and saving by part number.
1
Step 1 of 8Use an auto program for parts we bend again and again over the months, and for parts with multiple bends.
2
Step 2 of 8From the main menu, create a New product.
3
Step 3 of 8Enter the material and thickness, then draw the profile on the screen.
4
Step 4 of 8
Pick the tooling according to the bending chart.
5
Step 5 of 8
Let the controller work out the bend sequence. Check whether it throws a collision code anywhere in the sequence.
6
Step 6 of 8
If the sequence is wrong, show the bend sequence and swap the bends into the right order.
7
Step 7 of 8Save the program, named by the part number.
8
Step 8 of 8Do a test part in the same thickness before you bend the job.