Knowby
Laser 09 – Running, pausing and restarting
HSG Laser > Production. Running a nest from the handheld controller, what to watch while it cuts, and restarting after an alarm or crash.
HSG Laser > Production. Running a nest from the handheld controller, what to watch while it cuts, and restarting after an alarm or crash.
1
Step 1 of 5
<p>Start, pause and stop the job with the buttons on the handheld controller: START, PAUSE and STOP.</p>

Start, pause and stop the job with the buttons on the handheld controller: START, PAUSE and STOP.

2
Step 2 of 5
<p>Only press STOP if you mean it. After a stop the cut can&#39;t be resumed and the nest starts again from the beginning.</p>

Only press STOP if you mean it. After a stop the cut can't be resumed and the nest starts again from the beginning.

3
Step 3 of 5
<p>After an alarm or crash, back up one jog and resume the cut.</p>

After an alarm or crash, back up one jog and resume the cut.

4
Step 4 of 5
<p>While it cuts, check the sparks are coming out evenly from the bottom of the sheet.</p>

While it cuts, check the sparks are coming out evenly from the bottom of the sheet.

5
Step 5 of 5
<p>On anything thicker than 6 mm, pause halfway through and pull a part out to check the cut is good.</p>

On anything thicker than 6 mm, pause halfway through and pull a part out to check the cut is good.