Knowby
Brake 14 – Bend problems and fixes
Press brake category. Common bend problems and what to adjust.
Press brake category. Common bend problems and what to adjust.
1
Step 1 of 6
<p>Angle open (under-bent) from springback: adjust the correction A1–A2 (Brake 09, step 5).</p>

Angle open (under-bent) from springback: adjust the correction A1–A2 (Brake 09, step 5).

2
Step 2 of 6
<p>Angle different at each end: adjust α1 and α2 separately. Left and right are set on their own.</p>

Angle different at each end: adjust α1 and α2 separately. Left and right are set on their own.

3
Step 3 of 6
<p>Angle tight in the middle and open at the ends (or the reverse) on long parts: adjust crowning (Brake 10).</p>

Angle tight in the middle and open at the ends (or the reverse) on long parts: adjust crowning (Brake 10).

4
Step 4 of 6
<p>Flange length wrong: check the back gauge finger position (Z1/Z2) and the part is hard against both fingers.</p>

Flange length wrong: check the back gauge finger position (Z1/Z2) and the part is hard against both fingers.

5
Step 5 of 6
<p>Cracking on the outside of the bend: check the grain direction (Brake 09) and the die opening. A wider V helps.</p>

Cracking on the outside of the bend: check the grain direction (Brake 09) and the die opening. A wider V helps.

6
Step 6 of 6
<p>Marks on the part: clean the tooling, or use a wider V.</p>

Marks on the part: clean the tooling, or use a wider V.