

Brake 09 – First-off bend, grain check and angle correction
Category: Ragos Press Brake > Production. HIGH IMPORTANCE: check grain direction before the first bend. Then bend a first-off, measure it and correct the angle.
Category: Ragos Press Brake > Production. HIGH IMPORTANCE: check grain direction before the first bend. Then bend a first-off, measure it and correct the angle.
1
Step 1 of 6HIGH IMPORTANCE: before the first bend, check the grain direction matches the job notes and parts list.
2
Step 2 of 6If a part has been cut with the wrong grain, don't bend it. Stop and ask the manager.
3
Step 3 of 6
Do a test bend on material of the same thickness.
4
Step 4 of 6Measure the bend with verniers and the angle gauge.
5
Step 5 of 6
Change the correction to suit. Set it on the first bend and it stays the same on all the bends. Apply it across the whole length. Angle corrections are on the Auto main page as Corr α1 and α2 (left and right, 3.50° in this example).
6
Step 6 of 6
Measure the flange lengths and the finished part against the drawing with a tape or verniers.