Knowby
Laser 24 – Cut quality: what good looks like and fixing bad cuts
Laser category. How to judge a cut edge and what to check, in order, when it's bad. [REVIEW: general fibre-laser practice]
Laser category. How to judge a cut edge and what to check, in order, when it's bad. [REVIEW: general fibre-laser practice]
1
Step 1 of 7
<p>A good cut has a smooth edge with fine, even lines, little or no dross on the bottom, square sides, and parts that fall or knock out easily.</p>

A good cut has a smooth edge with fine, even lines, little or no dross on the bottom, square sides, and parts that fall or knock out easily.

2
Step 2 of 7
<p>Dross stuck on the bottom: usually speed too slow or fast, low gas pressure, or wrong focus. Check the nozzle first.</p>

Dross stuck on the bottom: usually speed too slow or fast, low gas pressure, or wrong focus. Check the nozzle first.

3
Step 3 of 7
<p>Not cutting through: speed too fast, power too low, or a dirty protective window. Check the window (Laser 15).</p>

Not cutting through: speed too fast, power too low, or a dirty protective window. Check the window (Laser 15).

4
Step 4 of 7
<p>Rough or burnt edge on mild steel with oxygen: speed too slow or too much oxygen pressure.</p>

Rough or burnt edge on mild steel with oxygen: speed too slow or too much oxygen pressure.

5
Step 5 of 7
<p>One side good and one side bad: the nozzle isn&#39;t centred (Laser 13), or the nozzle is damaged.</p>

One side good and one side bad: the nozzle isn't centred (Laser 13), or the nozzle is damaged.

6
Step 6 of 7
<p>Check in this order: nozzle condition (Laser 12), protective window (Laser 15), centring (Laser 13), ceramic (Laser 17), then the parameter. Only change the parameter with manager approval (Laser 04).</p>

Check in this order: nozzle condition (Laser 12), protective window (Laser 15), centring (Laser 13), ceramic (Laser 17), then the parameter. Only change the parameter with manager approval (Laser 04).

7
Step 7 of 7
<p>On anything over 6 mm, pull a part halfway through the sheet to check it (Laser 09).</p>

On anything over 6 mm, pull a part halfway through the sheet to check it (Laser 09).