Knowby
Laser 07 – Using the vacuum lifter
HSG Laser > Production. Loading sheet onto the laser bed with the KN Cranes vacuum lifter (SWL 1500 kg). Laser operator only. Hazards: see the OHS consultant's lifting SOP. Never stand under a suspended load.
HSG Laser > Production. Loading sheet onto the laser bed with the KN Cranes vacuum lifter (SWL 1500 kg). Laser operator only. Hazards: see the OHS consultant's lifting SOP. Never stand under a suspended load.
1
Step 1 of 8
<p>This is our KN Cranes HP-BSJ1500-8S vacuum lifter. Safe working load 1500 kg (1.5 t), for sheet up to 25 mm. Only the laser operator runs it.</p>

This is our KN Cranes HP-BSJ1500-8S vacuum lifter. Safe working load 1500 kg (1.5 t), for sheet up to 25 mm. Only the laser operator runs it.

2
Step 2 of 8
<p>Position the pads in the centre of the sheet so it stays level when lifted. Keep every pad on the sheet, not over the edge or over holes. If a pad is over the edge, shut off the valve to that pad.</p>

Position the pads in the centre of the sheet so it stays level when lifted. Keep every pad on the sheet, not over the edge or over holes. If a pad is over the edge, shut off the valve to that pad.

3
Step 3 of 8
<p>Lower the lifter onto the sheet, then press POWER to start it.</p>

Lower the lifter onto the sheet, then press POWER to start it.

4
Step 4 of 8
<p>Slide the handle forward into the vacuum position. Wait until the vacuum reaches the set level on the gauge and the vacuum light comes on before lifting.</p>

Slide the handle forward into the vacuum position. Wait until the vacuum reaches the set level on the gauge and the vacuum light comes on before lifting.

5
Step 5 of 8
<p>Lift no more than 25 mm and check only one sheet has come up. Sheets can rust together. If a second sheet is stuck underneath, keep everyone clear, stay at 25 mm or lower, and give the lifter a short jerk so the second sheet drops back onto the stack. Never do this any higher.</p>

Lift no more than 25 mm and check only one sheet has come up. Sheets can rust together. If a second sheet is stuck underneath, keep everyone clear, stay at 25 mm or lower, and give the lifter a short jerk so the second sheet drops back onto the stack. Never do this any higher.

6
Step 6 of 8
<p>Lift the sheet with the pendant and lower it onto the laser bed.</p>

Lift the sheet with the pendant and lower it onto the laser bed.

7
Step 7 of 8
<p>Slide the handle back and turn the vacuum off.</p>

Slide the handle back and turn the vacuum off.

8
Step 8 of 8
<p>Lift the lifter slowly so the pads release, then swing it back to its home position, out of the way.</p>

Lift the lifter slowly so the pads release, then swing it back to its home position, out of the way.